« previous next »
Pages: 1 [2]   Go Down

Author Topic: Just found this  (Read 8706 times)

0 Members and 1 Guest are viewing this topic.

Offline Kbricks for me

  • Jr. Member
  • **
  • Posts: 26
  • Karma: +0/-0
    • View Profile
  • My K bike model:: K1100LT and K75s
  • Modifications and add-ons:: NO ABS on either
  • Location:: North Durham near Gods country
Re: Just found this
« Reply #15 on: March 12, 2015, 12:13:22 pm »
Sorry I should have mentioned that the replacement pipes after removing the ABS are intended for 'R1150-1200 models.

However I asked if the brake pipe system for the earlier K100RS/RT/C models should/could be made to fit and the answer was possibly with modifications.

Hopes this helps
Logged
Sometimes I sits and thinks! Other times I just sits

Offline TomL

  • Hero Member
  • *****
  • Posts: 3107
  • Karma: +49/-5
    • View Profile
  • My K bike model:: K1300S
  • Location:: Hertfordshire
Re: Just found this
« Reply #16 on: March 12, 2015, 01:01:50 pm »
I removed the ABS from my 2003 R1150GS by making up a couple of copper pipes.


These are the front brake pipes under the tank.


The two pipes were removed back to the ABS unit and replaced by this copper loop.


These are the rear brake pipes which were removed.


I replaced them with this pipe and afterwards realised that the union could have been joined directly without the copper loop.


I then removed the complete ABS module to avoid carting around unnecessary junk.
Logged
As I have grown older, I've learned that pleasing everybody is impossible, but pissing everyone off is a piece of cake.
Pages: 1 [2]   Go Up
« previous next »