Bugger. As above, slipped on gravel and down we went (standstill). Not too bad damage wise - v mild gravel rash on rh engine casing low down. Can such damage be repaired, or are we looking at crazy prices. Could poss be touched in as an improvement, in which case any ideas re correct colour and or product to use?
Cheers,
Andrew.

I sent you an e-mail with a piccie. It's an odd e-mail address so check your trash etc.

Yep got it thank you  - the hornig site? Do you know if there's a phone holder that kind of attaches straight to this (in effect female to male i guess!!)
Thanks again,
Andrew.

Hi. Want to attach phone as sat nav on my 2013 K13R and S. Does the badge on the steering stem just pry up and what's underneath, ie what attachment route should i take. Is there an available threaded "hollow" i can access for gopro and or Ram mount etc?
Thanks for any assistance here.

Thanks all - i will take a peek (didn't know this)!!👍👍😎😎

Fair shout- cheers.

Quite poss - the R is instant power. The S, you have to roll the throttle a few degrees (never measured it) before you have a response. Its fine, but will get it looked at id it gets worse (and will mention when needs a service regardless).
Both good bikes though 👍👍

That's great, exactly what i wanted to know. They certainly look much less "messy" than the originals. Could i ask you where you have  attached the four "hoop" straps? I'm guessing the front 2 could loop arond the metal "bridge" that spans the half way point of the seat (or using the 2 straps already on the bike - from memory they're situated around that point) but I'm more wondering about the 2 at the back. Did you have to join 2 together like it shows on the fitment  video (which makes the new straps work very much like the old style), or is there some frame visible to use?
Apols questions and hope ok.
Thanks again, much appreciated,
Andrew.