General forum area > LT - All generations

K1200LT bodywork removal?

(1/3) > >>

Squadron Leader:
Anyone on here ever taken their own plastic bits off? I haven't a clue where to start.
Are there any step by step guides anywhere?
Mine's a 2004 "facelift" model I believe it's called.

Many thanks,

Phil

Costas:
Assume that the you haven't the ETK program or a tech support cd-rom.
Its now easy to do it fm here but here the best I can;
K1200LT 04 (0549-0559)
handle bar cover bottom left
handlebar cover top left
hc bottom right
hc top right
fork bridge cover
instrument cover
flange cap screw for trim upper (head mask)
trim upper prime
plastic supporting gasket of trim removed

screw on knee protector
fairing side knee protector
flanged cap screw of grid
support plague
plague (emblem)
hex nut under plague
moulting
nut moulting
sealing strip
flanged cap screw top
rubber buffer supporting panel under above screw
trim panel removed (same procedure for other side)

spoiler flanged cap screw
nut
spoiler center removed

flanged nuts (3)
nut (3)
stick on label
spoiler left
plug-in socket
spoiler left removed (same procedure for other side)
 
Hope that helps, at your disposal if need more assistance
 

raesewell:
And that's all there is to it  ;D ;D ;D

Squadron Leader:
That is helpful, thank you. Do any diagrams exist that point you the location of the fixings at all?

Costas:
Only the relevant cd-rom or the ETK program can help with diagrams at list from what I know.
I do not possess the relevant info for your bike. All I did was go to ETK (BMW spare parts program) read the diagrams there and post you the info found, wish I could do better.

Navigation

[0] Message Index

[#] Next page